Forum > The Garage

PIAA lights intermittent?

(1/2) > >>

macpac:
Folks:
I have been running PIAA lights for about 2 years on my '05 ST1300 with no complaints (installed by previous owner) and I have them on all the time during daylight riding.  They have gone out, but the PIAA switch shows green (they are wiring to come on with hi beam).  I took off battery cover and tried to find a loose connection but didn't find anything.  Tried again with just switch and engine off and they worked great. I drove 5 miles or so and they went out again. Now they won't come at all even engine off.  PIAA switch shows green so I guess the problem is somewhere between that switch and the lights??
Any suggestions as to where to look would be much appreciated.
Signed - in the dark (macpac).

HawkGTRider:
I have a set of PIAA 910s on my ST1100, but I don't think I can help (I have someone else do my mechanical stuff...especially electric). My knowledge of electrical stuff is limited to knowing that electricity is dependent upon keeping the smoke inside the wires. Once it gets out, stuff doesn't work anymore.

macpac:
Geoffrey - thanks, I believe I will consult the pros.
Bill

qman8:
There should be a relay between the switch and the lights.  Find it and look for damage and /or blow it out with compressed air if its not totally sealed.  THat relay will be connected to a power source point...trace that down and make sure its a good connection.  Once you pull apart the connections, put Dielectric Grease on the connection before putting it back together.


Good Luck.

macpac:
Thanks much. I'll work on it.

Navigation

[0] Message Index

[#] Next page